Gas Furnace. Heat won't stay on! It's gettin' cold in Utah.? - light blinking and furnace running continuosly
My house was built in '05, and I have an 80 Ultra V-tech oven gas. I have a digital thermostat, which has always been there. My problem is that I can not heat up on the phone in the car. I checked the pilot lights and not electric. It always comes in the aftermath of the changeover and then turn around 10 seconds later. I use the thermostat on the fan so I think the fan running again. I'm really bad at these things. I found another man who was sent in '08, which had the same problem, but not answered. I'll post. I hope someone can help me. I really appreciate. Thank you!
"Just temporarily moved into a rented house and has found a problem.
The house has 80 Ultra V tech furnace will not start. No heat and no fan when the car crashed.
I opened it and control the LED. Blinks continuously, which does not correspond to arbitrary code on the sticker on the door.
Anyone have any ideas or at least a link to the manual?
I have tried to change the switch, reset the filter and clean flame sensor. "
Thursday, February 18, 2010
Light Blinking And Furnace Running Continuosly Gas Furnace. Heat Won't Stay On! It's Gettin' Cold In Utah.?
2 comments:
Ik is correct if it is a hot surface igniter break (flat heating element, if you will look through the eyes of the Cross), probably an obstacle oriface driver. Do not play with him. If you love your eyebrows. that inflammation may be direct.
Draft inducer motor must fall just 1 beat and prooving near a switch. Vacuum circuit breaker or psi before the valve is working gas. usually occurs with the lighter. do u have cicadas in Utah? to plug everything in Central cal.call a pro.
Jus think you're right, the only thing that a few defective thermocouple or gas valve could be electronic. You must ensure that the flame sensor cleans well, you can not clean.
Post a Comment